PLEASE SELECT the desired connector VARIANT ABOVE!
Variant 1 with:
Servo connector:
Voltage range: 4.5 - 9 V via servo connector
Incl. module, loudspeaker, servo connector JR, sufficient cable lengths.
Tip: Switching possible by remote control. For this you need an RC switch / module or a receiver with switching function ON / OFF.
Variant: 2 with:
Battery clip 9 volts:
manually switchable via a slide switch (ON / OFF)
Voltage range 4.5V- 9 volts per 9 volt battery clip or other connector types are possible
Power can be supplied via a 9 volt battery or your drive battery (not included)
Incl. module, loudspeaker, switch, battery clip, sufficient cable lengths.
The module can be operated up to 12 volts and max.2Ah. You can also use any other connector type (2-pin).
To do this, choose variant 3: open cable end without switch.
Details size:
Noise board: 35x46x 4 mm
Speaker diameter: 40mm
Duration: permanent, endless ...
Max. Load capacity of the board: 2Ah
The soundset is ready for installation. You can place these electronics with the loudspeaker anywhere in your model. Sufficient cable lengths.
Do you have a special sound requirement for your model?
We can play any sound / music / tone on the electronics for you
Just talk to us before buying.
We are happy to use your existing clay. Simply send the file to us and we will see if it is compatible.
This product is compatible with (for example):
This product is similar to:
Customers who bought this product bought also the following products:
.jpg "Preview: Flat Light bar / light bar / blue light bar / light bar in BLUE with flash illumination")
